-40%
2 Sheets Photopolymer Plate Rubber Stamp Making DIY Craft Letterpress Polymer
2 Sheets Photopolymer Plate Rubber Stamp Making DIY Craft Letterpress Polymer
2 Sheets Photopolymer Plate Rubber Stamp Making DIY Craft Letterpress Polymer

2 Sheets Photopolymer Plate Rubber Stamp Making DIY Craft Letterpress Polymer

$ 7.91

Availability: 27 in stock
  • Return shipping will be paid by: Buyer
  • Brand: Unbranded/Generic
  • Non-Domestic Product: No
  • Refund will be given as: Money back or replacement (buyer's choice)
  • Custom Bundle: No
  • MPN: Does Not Apply
  • Item must be returned within: 30 Days
  • All returns accepted: Returns Accepted
  • Modified Item: No
  • Condition: New

    Description

    Stamp Making DIY
    Photopolymer Plate
    Photopolymer plates, or solar plates as they are also known, are used in the flexographic printing industry. They have also been used by Artist Printmakers for many years, and can be used to make personal stamp easily.
    Making the plates is easy and can be done in the home, no harmful or dangerous chemicals are needed and the  equipment used is easily and cheaply obtained.
    Size:
    20X30CM (7.9"X11.8")
    Photopolymer Thickness:
    1mm(0.04")
    DIY Stamp Making Instruction:
    1. Print the image that you want to use to create your photopolymer plate on a transparency sheet using an inkjet  printer. Cut a piece of photopolymer plate 1/4 inch wider and taller than the design on the transparency sheet, using the metal shears. Trim the transparency to the same size as the  plate.
    2. Cut the two pieces of clear acrylic the same size as the plate, using the metal shears. Remove the protective film from the surface of the plate that will be exposed. Position the plate on one piece of acrylic. Place the transparency on the surface of the photopolymer plate with the ink side down. Place the second piece of acrylic on top of the  transparency.
    3. Place the clamps on each of the four sides of the acrylic, plate and transparency, to hold them together. Place the entire assembly under an ultraviolet lamp. Set a timer for 1 minute.
    4. Turn on the lamp and activate the timer. Turn the ultraviolet lamp off when the timer reaches the set time.  Remove the exposed plate and remove the clamps from it.
    5. Place the exposed plate under 4 or 5 cups of clean water in a large plastic bowl. Brush away the soft  unexposed photopolymer from the surface of the plate using a soft nail brush. Hold the plate under water and use a firm circular scrubbing motion.
    6. Dry the plate using a hair dryer on low heat. Set the timer for 1 minute, and place the dry plate under the  ultraviolet lamp for a final hardening. Turn off the lamp and remove the plate.
    This listing is for:
    Two Sheets of 20X30CM (7.9"X11.8") Photopolymer Plate
    Thank you for choosing our product
    If you have any questions, please contact us before purchasing,
    We will do our best to respond immediately during normal business hours.
    For some reason, if you are not satisfied with our products or service, please
    contact us.
    Items will be shipped out by e-pack within 3 business days upon your payment cleared, normally shipping takes approximately 10-18 business days. For
    international buyers
    please contact us for shipping details.
    All our items will be shipped to buyer’s
    PayPal address